Reliable and fast

End plates

The inflow and outflow holes in the round profile should always be as high or as low as possible.

To prevent air pockets, and therefore non-galvanised spots, and to ensure that the excess zinc flows away, the holes should always be in the corners of the profile. In this case, the profile is round and the assembly holes can be used to determine what the top and bottom is. The inflow and outflow holes should therefore be drilled at high and as low as possible.

Cookies on the Rotocoat websites

To make our website more user-friendly and to tailor it more closely to your preferences, we use cookies and similar techniques.

We ask your consent to place social media cookies and marketing cookies. Social media buttons are required to use the social media buttons on our websites. Marketing cookies allow us to provide you with targeted information that is relevant for you at the present time.

By clicking on Accept, you give us consent to place social media and marketing cookies. Go to Cookie settings to make your own selection of the cookies that will be placed. You can always adjust your preferences. For more information, read our cookie policy.